User's Manual

1.9.2 Tube Unit + Probe Stand Installation
1. Carefully lift up the articulation probe.
2. Move the Probe Stand along the articulation probe towards the probe
strain relief.
3. Align the Probe Stand’s screw with the connector on the articulation probe
(the long side of the stand must face inwards toward the battery release
of the probe).
4. Carefully tighten the screw.
CAUTION:
Do not remove the screw from the probe stand.
Be careful to not overtighten the screw.
Always use a screwdriver to fasten screws.
- 15 -- 14 -