Manualshelf

User's Manual

ManualsBrandsMedical Data Electronics ManualsElectronicsMedical Telemetry Transmitter
11121314151617181920
17
Troubleshooting
If Problem Is… Try This…
Excessive noise or artifact on display. Check skin prep. Check
electrodes. Placement may be
causing motion pick-up.
Signal loss. Electrode is lost or disconnected.
Central station displays telemetry squelch even after
batteries are removed from the Angel MP.
Turn receiver off at the Vision.
Refer to Vision Operator’s
Manual.
Angel MP telemetry is not displayed at the Vision.
Replace batteries.
Ensure battery cover switch is in
the "ON" position.
Check transmitter channel at the
Vision.
Can not activate pace detect. Must be done at Vision central.
Can not set heart rate alarms. Must be done at Vision central.