User's Manual

Operation of Angel MP Transmitter

Power Up

The Angel MP transmitter will activate upon placement of three 1.5V AAA alkaline batteries into

battery compartment and turning the knob on battery cover to the ON position. Placement of

batteries and turning the knob to ON automatically enables the telemetry receiver at the Central

(if transmitter is programmed and assigned a window at the Central).

CAUTION: To avoid damage to transmitter, use only 1.5V AAA

alkaline batteries.

To install batteries and activate transmitter:

1. Access battery compartment by turning the knob on battery cover to the OFF position and

removing cover.

2. Install batteries (noting correct polarity) as shown in the following illustration, install battery

cover and turn the knob to the ON position.