User's Manual

Message #6

If tile selected does not contain an admitted patient, but has a good signal, and has a Low

Battery indication, on-screen keyboard displays and says:

ANGEL TRANSMITTER ADMIT: ENTER PATIENT INFORMATION.

a. Using on-screen keyboard, enter PATIENT NAME, PATIENT ID, and LOCATION.

b. Touch ENTER to begin programming operation. ADMITTING PATIENT…is

displayed at top of on-screen keyboard.

c. After programming completes successfully, the following message is displayed:

Programming Complete

Remove the Angel Transmitter from the Programming

Port and write the Patient ID on the Angel Transmitter.

Remove transmitter from Vision base, the following message is displayed:

Has the Patient ID been written on the Angel Transmitter?