User Manual

Problem May Be Caused By... Try This...

Bedside monitor’s antenna

and or transceiver are

missing and/or loose.

Check connection to

transceiver and antenna

connection. Tighten or

replace if necessary.

Ensure transceiver’s LED

is “on”. Check test page of

monitor’s network status

on RF transponder’s hex

code.

Recorder Errors

Problem May Be Caused By... Try This...

No recording. Recorder out of paper. Remove old paper cylinder

(if present), and install new

roll of paper.

Paper was installed

backwards.

Remove paper roll and

reinstall, noting proper

orientation.

Paper is jammed. Verify paper is loaded and

aligned correctly. If

evidence of a jam exists,

remove paper carefully;

clean out all jammed paper

and reinstall roll, paying

particular attention to

proper orientation.

Door not closed properly. Reopen and close recorder

door.

ALARM RECORD turned

OFF on Hard Copy Setup.

Open Hard Copy Setup

popup and make sure

ALARM RECORD is

turned “ON.”