User Manual

17
Message #4
WARNING! – ACTIVE TRANSMITTER ON PATIENT <Name> CHANNEL <Channel> –
CONTINUE?
a. Touch
YES
if you wish to replace transmitter (or touch
NO
to cancel).
b. After programming completes successfully, the following message is displayed:
TRANSMITTER READY – WRITE <Name> AND <New Channel> ON TRANSMITTER
Touch
OK
, the following message is displayed:
DEACTIVATE OLD TRANSMITTER PRIOR TO ACTIVATING NEW TRANSMITTER
c. Touch
OK
, remove new transmitter from Vision base, write patient name and channel number on
transmitter, and
deactivate the old transmitter
.
Message #5
ACTIVE TRANSMITTER ON CHANNEL <Channel> – DEACTIVATE OLD TRANSMITTER –
CAN NOT ASSIGN
a. Touch
OK
, remove new transmitter from Vision base and
deactivate old transmitter
.
b. Start again from
Step 3
in the previous section
Instructions for Programming the Angel
Transmitter
.
Message #6
If tile selected does not contain an admitted patient, but has a good signal, and has a Low Battery
indication, on-screen keyboard displays and says:
TRANSMITTER ADMIT: ENTER PATIENT INFORMATION
a. Using on-screen keyboard, enter
PATIENT NAME, PATIENT ID
, and
LOCATION
.
b. Touch
EXIT
to begin programming operation.
ADMITTING PATIENT…
is displayed at top of
on-screen keyboard.
c. After programming completes successfully, the following message is displayed:
TRANSMITTER READY – WRITE <Name> AND <Channel> ON TRANSMITTER
Touch
OK
, the following message is displayed:
DEACTIVATE OLD TRANSMITTER PRIOR TO ACTIVATING NEW TRANSMITTER
d. Touch
OK
, remove new transmitter from Vision base, write patient name and channel number on
transmitter, and
deactivate the old transmitter
.