User Manual

16
What to do if you encounter these Messages:
Message #1
TRANSMITTER ADMIT: ENTER PATIENT INFORMATION
a. Using on-screen keyboard, enter
PATIENT NAME, PATIENT ID
, and
LOCATION
.
b. Touch
EXIT
to begin programming operation.
ADMITTING PATIENT…
is displayed at top of
on-screen keyboard.
c. After programming completes successfully, the following message is displayed:
TRANSMITTER READY – WRITE <Name> AND <Channel> ON TRANSMITTER
Touch
OK
, remove transmitter from Vision base, write patient name and channel number on
transmitter.
Message #2
PATIENT CURRENTLY ADMITTED – CONFIRM ASSIGNING TRANSMITTER TO
<Patient> ON CHANNEL <Channel>
a. Touch
YES
if this is desired patient
(touching NO will allow you to discharge patient and admit
new patient as described in Message #1)
.
b. After programming completes successfully, the following message is displayed:
TRANSMITTER READY – WRITE <Name> AND <Channel> ON TRANSMITTER
Touch
OK
, remove transmitter from Vision base, write patient name and channel number on
transmitter and go to.
Message #3
PATIENT CURRENTLY ADMITTED – REPLACE TRANSMITTER ON PATIENT <Name>
CHANNEL <Current Channel>?
a. Touch
YES
to replace transmitter.
b. After programming completes successfully, the following message is displayed:
TRANSMITTER READY – WRITE <Name> AND <New Channel> ON TRANSMITTER
Touch
OK
, the following message is displayed:
DEACTIVATE OLD TRANSMITTER PRIOR TO ACTIVATING NEW TRANSMITTER
c. Touch
OK
, remove new transmitter from Vision base, write patient name and channel number on
transmitter, and
deactivate the old transmitter
.