User Manual

Page 8

After programming completes successfully, the following message is displayed:

TRANSMITTER READY – WRITE <Name> AND <Channel> ON TRANSMITTER

Touch

, the following message is displayed:

DEACTIVATE OLD TRANSMITTER PRIOR TO ACTIVATING NEW TRANSMITTER

Touch

, remove the new transmitter from the Vision base, write patient name and channel

number on transmitter, and

deactivate the old transmitter prior

to going to

Step 5

below.

Step 5.

After programming is complete, remove tape on both halves of foam to expose adhesive.

Step 6.

Close and press the foam programming head together to activate Stickman.

NOTE:

If an

ASSIGNMENT ERROR

message is displayed at any time

during programming, write down the displayed

CODE

number and contact

MDE Technical Support for assistance.