User Manual

Page 4
Scenario #2
Patient Admitted in Tile and has No Signal
If the tile selected contains an admitted patient and has no signal, a popup displays and says:
PATIENT CURRENTLY ADMITTED – CONFIRM ASSIGNING TRANSMITTER TO
PATIENT <Name> ON CHANNEL <Channel>?
a. Touch
YES
if this is desired patient
(touching NO will allow you to discharge patient and admit
new patient as described in Scenario #1)
.
b. After programming completes successfully, the following message is displayed:
TRANSMITTER READY – WRITE <Name> AND <Channel> ON TRANSMITTER
Touch
OK
, remove the transmitter from the Vision base, write patient name and channel number on
transmitter and go to
Step 5
on page 8.