User's Manual

2/ The antenna must be installed such that 20 cm is maintained between the antenna and users, and
3/ The transmitter module may not be co-located with any other transmitter or antenna,
4/ For all products market in CANADA, OEM has to limit the operation channels in CH1 to CH11 for 2.4GHz band by
supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory
Domain change.
As long as 3 conditions above are met, further transmitter test will not be required. However, the OEM integrator is
still responsible for testing their end-product for any additional compliance requirements required with this module
installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the IC authorization is no longer considered valid and the IC ID can not be
used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate IC authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains TX IC : 7542A-RT3593”.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this
RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.
אՀᤞ፿ᔞش؀᨜چ೴
ᆖীڤᎁᢞٽ௑հ܅פ෷୴᙮ሽᖲΔᆖ๺ױΔֆ׹Ε೸ᇆࢨࠌش݁լ൓ᖐ۞᧢ޓ᙮෷ΕףՕפ෷ࢨ᧢ޓ଺๻ૠհ௽
ࢤ֗פ౨Ζ
܅פ෷୴᙮ሽᖲհࠌشլ൓ᐙ᥼ଆ౰ڜ٤֗եឫٽຏΙᆖ࿇෼ڶեឫ෼ွழΔᚨمܛೖشΔࠀޏ࿳۟ྤեឫழֱ൓
ᤉᥛࠌشΖছႈٽຏΔࠉሽ๵ࡳ܂ᄐհྤᒵሽຏΖ܅פ෷୴᙮ሽᖲႊݴ࠹ٽຏࢨՠᄐΕઝᖂ֗᠔᛭ش
ሽᘿ୴ࢤሽᖲ๻ໂհեឫΖ
ڇ5.25-5.35⁘᎒(GHz)᙮൅փᖙ܂հྤᒵᇷಛႚᙁ๻ໂΔૻ࣍৛փࠌشΖ
ءᑓิ࣍࠷൓ᎁᢞ৵ലࠉ๵ࡳ࣍ᑓิء᧯ᑑقᐉٽ௑᧘Δࠀ૞ޣؓ؀Ղᑑقψءข঴փܶ୴᙮ᑓิΚID ᒳᇆω