BTG200 Quick Start Guide Revision 1.
Step 1. Please power on BTG200 with provided power adapter. Once properly powered on, the PWR light will stay on with green light. Step 2. Default IP of BTG200 is 192.168.100.1. Please configure your programming device to 192.168.100.10, connect directly to BTG200 and access via the url below. http://192.168.100.1 By default, no password is set, please setup root password according to the Property Installation Worksheet. Step 3. Once password is set, please login via the same url http://192.168.100.
Step 4. Once logged in, please select the Network Tab for Network Configuration.
Step 5. Please select Station Mode, then select with WiFi SSID provided in the Property Installation Worksheet.
Step 6. BTG200 will restarted after SSID and WPA Key is entered. Please allow 3~5 Minutes for restart. The WIFI green LED in the front will blink when property connected to the internet. If WIFI/NET Led is not blinking, please contact support.
RF exposure warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
