User guide

Chapter 6 - NioNode SNMP control
74 Version 1.7.2.0 March 27, 2015
Installing the SNMP program and compiling the MIB file
NWare includes a NION MIB file that is required in order to use SNMP with a NioNode.
However, this file is uncompiled and needs to be compiled before you can use it. It can only
then be used with an SNMP program, like MIB Browser.
 Installing the SNMP program and compiling the MIB file
1. Download the SNMP program and follow the instructions to complete the installation.
You can download MG-SOFT MIB Browser here
(http://www.mg-soft.com/mgMibBrowserPE.html).
2. Open the MIB compiler program.
3. Open the uncompiled NION MIB file, PEAVEY-NION-NIONODE-MIB-V2.my in the
<NWare install>\plugins\pion\doc folder.
4. Compile the file to create a .MIB file.
Connecting the SNMP program to the NioNode
1. Start the SNMP program and load the NION MIB file.
2. Connect to the NION using its IP address.
3. Expand the MIB tree to show the nodes under the nionode part of the tree.