User guide

External control user guide
March 27, 2015 Version 1.7.2.0 69
2. Under Services, select the check box next to SNMP.
Setting up the NWare SNMP project
Up to 255 NWare controls can be accessed in a project using SNMP. You need to manually
specify the number of controls you want to access. You can optionally assign them labels.
Each control is then exported as an OID.
 To set up the NWare SNMP project
1. Expand the Hardware folder in the device tree, then drag a NioNode over to the design
page.
2. In the Number of SNMP exported controls box on the device properties, specify the
number of controls (knobs, faders, LEDs etc.) you would like to access using SNMP.
3. Click OK.
An SNMP Exports tab will now be available on the NioNode control surface. This allows
you to toggle controls between read-only and read/write and specify labels that will be
available in your SNMP program.