User guide

March 27, 2015 Version 1.7.2.0 45
In This Chapter
Introduction ....................................................................................................... 45
Introduction
RATC2 RAW is a variant of the RATC2 protocol. It allows you to access controls in a project
using control aliases in the same way as RATC2, but the aliases are defined automatically.
You do not need to manually specify them for each control in NWare.
In the example below, the knob control has been automatically assigned a RUID (Relatively
Unique ID) of control_1 by NWare. This name can be used to reference the knob using
RATC2 RAW.
Chapter 4
RATC2 RAW