User manual

  1  '   ) 8 3 8 )   ) 8 3  &     5  



CAB 4n Software Device Features:
LINK LED This LED will turn ON when a valid connection has been established between the
CAB 4n and the network switch. This function is duplicated on the front panel of the CAB 4n.
ID The four digit number is the user-defined Hardware Base Address. The range is hex, between
0000 and FFFF. The LED will turn ON when a valid number is entered. Each CAB 4n on the
network must have a unique ID. If there is a duplicate, or the value is zero, this LED will not
light, and communications between the CAB and network is not valid.
BUNDLE User defined number that assigns for a CAB 4n four (4) audio channels to a
CobraNet™ network “bundle”. The range is OFF to 32,767. For switched networks, the number
must be 256 or higher, (numbers below this are reserved for broadcast bundles). This number
must also be set in the CobraNet I/O device (CM-1 table for each specific Nion unit) for which
the CAB will transport audio. The LED is ON when the CAB 4n is receiving the specified
network bundle.
Each CAB 4n can receive up to four separate audio bundles of 4Ch each. GAIN Software control
of the CAB 4n’s analog gain stage is Gesturable from the knob or the digital window located just
above each knob. The range is -95 dB to +30 dB.