User guide

MWN-WAPR150N Wireless-N Broadband Router
Frequently Asked Questions


10
MedialinkProducts|1951OldCuthbertRoadSuite301CherryHillNJ08034|Phone:856‐216‐8222
[e-mail]|www.medialinkproducts.com
Open an internet browser and type the IP address of the router into the address bar
(192.168.0.1)
Enter the default UN and PW "admin" for both
Then click on WLAN Settings>Security Settings
Change the Security mode from WPA-Personal to Mixed WEP
Make sure default key is set to Key 1
Next to Key 1 change the character type from "Hex" to "ASCII"
Enter a password that is exactly 13 characters. (Can be case-sensitive letters,
numbers or symbols)
Click Apply.
Disconnect the ethernet cable and try to connect to your wireless network again.
3b. My wireless device says I am wirelessly connected to the router but I cannot access
the internet.
First make sure you are able to connect to the internet when you have any device plugged
directly into the router via Ethernet. If you cannot access the internet when you are plugged into
the router, please see Section 1, Question 10a
on page 5 of this FAQ. .
If you can access the internet when you are plugged into the router, then make sure your
wireless adapter is set to “Obtain an IP Address Automatically via DHCP”.
XP Users: Start > Control Panel > Network Connections > Right Click Wireless Network
Connection > Properties > Highlight “Internet Protocol TCP/IP > Click Properties > Select
“Obtain an IP Address Automatically” and “Obtain DNS Servers Automatically”.
Vista Users: Start > Control Panel > Network and Internet > Network and Sharing Center >
Manage Network Connections > Right Click Wireless Network Connection > Properties >
Highlight “Internet Protocol Version 4” > Click Properties > Select “Obtain an IP Address
Automatically” and “Obtain DNS Servers Automatically”.
Win 7 Users: Start > Control Panel > Network and Internet > Network and Sharing Center >
Change Adapter Settings > Right Click Wireless Network Connection > Properties > Highlight
“Internet Protocol Version 4” > Click Properties > Select “Obtain an IP Address Automatically”
and “Obtain DNS Servers Automatically”.