Operating instructions

31
MAKING USER SETTINGS (cont.)
If you have not done so already, put your set-top into “user settings mode”, as described on page 20.
1. Press the U or D button on your remote control and highlight Restore Defaults on the PACE
USER SETTINGS menu.
2. Press the R button. The message: “Restore Default. Press OK to confirm” appears on your TV
screen.
3. To confirm and restore the factory settings, press the select button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 21 onwards. If you have
finished changing the settings, press the POWER button. Your set-top will switch on with the
restored settings.
NOTES
If your set-top and HDTV are connected via a standard HDMI
TM
cable, your HDTV may pass information
about the required settings back to your set-top (see page 22). If you wish to restore your set-top’s
settings to those created by your HDTV, you should disconnect your set-top from your HDTV before
you restore the factory default settings. When you reconnect your HDTV to your set-top via the HDMI
TM
cable, your HDTV will pass back the information again.
Always turn off your set-top, wait 60 seconds, then disconnect your set-top from the wall AC
outlet before you connect or disconnect any other equipment to or from its rear panel.