Operating instructions

Setting Hard Disk Sleep Mode

If your set-top is in Hard Disk (Hdd) Sleep Mode, any attached external hard disk will enter sleep

mode when you switch off your set-top (that is, when the front-panel POWER light is red and the

set-top is in standby). This is an energy-saving feature.

If you have set up your set-top to make recordings, the set-top and external hard disk will switch on

to allow those recordings to be made, even if this “Standby Sleep Mode” feature is on (set to “YES”).

However, it will take a little more time to do so, compared with having Standby Sleep Mode off (set

to “NO”).

1. If you have not done so already, put your set-top into “user settings mode”, as described on page

20. Press the U or D button on your remote control and highlight Hard Disk Sleep Mode on the

PACE USER SETTINGS menu.

2. Press the R button. The Standby Sleep Mode menu, shown right, appears on your TV screen.

3. If you want to change the setting, press U or D. Press the select button to conﬁrm the choice

and change to the new setting.

4. Press the L button. The PACE USER SETTINGS menu reappears.

To continue making the settings, see the next section.

MAKING USER SETTINGS (cont.)

Standby Sleep Mode

>YES

> shows current setting, as does

a lighted MESSAGE light