Operating instructions

3 If you wish to reset all the Closed Caption settings to their default values (mainly Auto), press the

D button to highlight “Reset to Defaults” in the menu, then press select.

4. When you have made all the changes you want to make, press L twice to re-display the PACE

USER SETTINGS menu.

Making Front-Panel Settings

You can use the Front Panel Settings menu to set the brightness level of the front-panel lights (but

not the POWER light) when your set-top is being used (“Viewing TV” level) and when it is switched

off (“Standby” level).

The remaining setting “IR Receiver” is not applicable to this product, and cannot be changed.

1. If you have not done so already, put your set-top into “user settings mode”, as described on page

20. Press the U or D button on your remote control and highlight Front Panel Settings on the

PACE USER SETTINGS menu.

2. Press the R button. The Front Panel Settings menu, shown right, appears on your TV screen.

3. Press the U or D button to highlight “Standby Level” or “Viewing TV Level” as required.

4. Use the select button to choose the setting you want (the setting changes each time you press

select): “Low”, “Std” (Standard) or “High”. Look at the dimming and brightening of the front-

panel lights while you are making the settings, to see the effect of your selections.

5. When you have made all the changes you want to make, press L to re-display the PACE USER

SETTINGS menu.

MAKING USER SETTINGS (cont.)

Front Panel Settings

Standby Level : Std

Viewing TV Level : High

IR Receiver : NA