User manual

KNR-p4Px4 KNR-p16Px8 User Manual
125
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration>Network
2. Select the General tab.
Figure 9. 1 Network Settings Interface
3. In the General Settings interface, you can configure the following settings: NIC Type, IPv4 Address, IPv4
Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.
Note: You need to configure the internal NIC address, so that IP addresses are assigned to the cameras
connected to the PoE or built-in switch interfaces.
Note: The valid value range of MTU is 500 ~ 9676.
4. After having configured the general settings, click Apply to save the settings.