WLAN REPEATER ECO MT4218 Quick Guide
EN Overview LAN socket Reset hole We recommend configuration via LAN with manual IP setting as shown below. 1. Open local network property Status LEDs Configuration Management is done via web browser, device is responding at address 192.168.2.1, default user: admin, default password: admin. In order to configure device you need to establish connection via LAN (connect your PC computer with ethernet cable) or WiFi (scan for new WiFi, select “7links-Repeater” network, enter default password: 12345678).
Now open your web browser and enter http://192.168.2.1 If prompted enter default user name (admin) and password (admin). Click “OK” and close network properties. If you want to extend your local WiFi network select option “Repeater”. Next click “Scan” to search available WiFi networks.
EN Select desired network, if problem with difference in broadcast channel occur – following windows will appear. Click “OK” on both windows in order to set the same channel of broadcast when you use repeater mode.
Now enter password for WiFi network you want to extend. EN Default name and password of repeater WiFi can be edited by user. Enter password Click “Save/Apply” and wait until new setting will be stored. Device will reboot automatically.
EN Now you can connect to new WiFi network “7Links-Repeater”. Go to wireless network and click “refresh network list”. Configuration is done. Select “7Links-Repeater” and enter password (default: 12345678). Changing password for management website Enter new password.
Factory reset EN Whenever you noticed strange behavior of device or you have forgotten password you can restore factory settings, simply put straighten paper clip into reset hole for 10 seconds (device must be powered from electric outlet). Troubleshooting regarding Repeater Mode Q: After configuration I can not enter management site 192.168.2.1 A: Set up manually IP address of your LAN or WiFi network card in your computer as described in this quick guide.
EN 8
