Instruction manual

How to use FTP Server settings:

Step 1: Enter the IP or HTTP address of the FTP server in

“IP/Host”

Step 2: Enter the designated FTP port number in “Port”

Step 3: Enter the account ID of the FTP server in “Account ID”

Step 4: Enter the FTP server password in “Password”

Step 5: Select whether you wish to use “Port Mode” or “Pas-

sive Mode” transfer protocol.

Step 6: Click on Submit when you are ﬁ nished.

5.5.3 DDNS Server

This menu allows you to enter your DDNS(Dynamic Domain

Name Server) Settings. You can also use a PPPoE (with dy-

namic IP) to connect to the http address of the IP WEBCAM

(such as sqIP WEBCAM.dyndns.org) by entering the regis-

tered HTTP address of the DDNS Server. This is convenient

for viewing IP WEBCAMS with non-ﬁ xed IP addresses.

Entering the DDNS Server Settings:

Step 1: Find a DDNS service (such as http://www.dyndns.

org ), and register a user account, password, and HTTP user

address.

Step 2: Enter the address (IP or HTTP) of the DDNS server.

Enter the host name, account ID, and password in each ap-

propriate ﬁ eld.

Step 3: Enter the account ID of the DDNS server in “Account ID”

Step 4: Enter the DDNS server password in “Password”

Step 5: Select the DDNS server connection status auto-

matic display setting.

Step 6: Click on “Submit” when you are ﬁ nished.

5.5.4 NTP Server

NTP(Network Time Protocol) allows you to calibrate the IP

WEBCAM timing.

Using the NTP Server settings:

Step 1: Enter the NTP Server IP or HTTP address in “IP/Host”

Step 2: Select the correct time zone in the “Time Zone”

Step 3: Click on “Submit” when ﬁ nished.

5.6 Administration Setup

This menu allows you to designate an IP WEBCAM name,

administrator password, and other user passwords. Admin-

istrators may access all IP WEBCAM functions and settings,

while general users may only utilize the LiveView view, and

may not access any of the settings.

TOP