Instruction manual

12
When using the “DHCP” setting, you do not need to enter
any of the above settings. You must only enter the address
of the DHCP Server in the “Server” fi eld.
When using the “PPPoE” setting, you must correctly enter
your ID and password. Please refer to unit 5.4.2 for details.
5.4.2 PPPoE
This menu allows you to enter the dial up settings during
PPPoE IP assignment. This usually refers to entering your
ID account name and password. Remember that you must
also enter your ISP settings as well.
How to Setup PPPoE
Step 1: Enter your correct user ID in the “Account” fi eld.
Step 2: Enter your correct password in the “Password” fi eld.
Step 3: Click on “Submit” to complete your settings.
NOTE: Because PPPoE utilizes a dynamic IP address
from an ISP, the IP settings for the MT4009 EZ IP WEB-
CAM could diff er for each use. It is thus suggested that
an IP Router be used to connect to the PPPoE or DDNS.
This will help your computer to fi nd the IP WEBCAM.
5.4.3 HTTP Server
This menu allows you to enter the port number of the
MT4009 IP WEBCAM internal web server
(or HTTP Server) via HTTP protocol. The default port num-
ber is “80”.
5.4.1 IP Assignment
Static IP Assignment refers to the fi xed settings of the ISP
or network engineering department.
IP Address: Includes static, DHCP, PPPoE. DHCP and PPPoE
are typically dynamic IPs.
When using the “static” setting, you must enter the follow-
ing information:
■ IP Address: The IP address of the IP WEBCAM
■ Subnet Mask: Set by default to 255.255.255.0
■ Gateway: Default gateway
■ Http Server port settings
■ DNS settings
* MAC Address: Displays the Mac address of the IP WEBCAM
TOP