Instruction manual

11
5.3 Event Trigger
This includes both event trigger settings and display, in-
cluding:
- Event: Entering events
- Trigger: Setting trigger
and picture capture times.
Detailed explanations are presented in the next chapter.
How to Use Event Settings:
Step 1: Engage Event for either set (MD will automatically
display the trigger sensitivity)
Step 2: After you are fi nished, click on Submit.
Step 3: Otherwise, click on Default to use factory default
settings (all sets off )
NOTE: After engaging either type of event, “Save in PC”
will automatically turn on.
5.3.2 Trigger
Event trigger image transfer settings, including:
■ Save in PC: The image fi le is saved in your computer.
■ Save in Flash Card: The image fi le is saved in the SD
Card.
■ Mail Image: Send captured event trigger image fi le by
e-mail.
■ FTP Image: Send captured event trigger image fi le by
FTP.
■ Shutter Timer: Change shutter time for event trigger
image capture.
2 seconds is the default setting.
5.3.1 Event
Event settings, including:
- Motion Detection (set 1)
- Motion Detection (set 2)
Either set signal input trigger can be engaged.
5.4 Network Setup
Network Setup can be used to change the network con-
nection settings of the IP WEBCAM. The default value for IP
assignment is “static”. These settings also include:
■ IP Assignment°GStatic,
■ DHCP, or PPPoE
■ PPPoE settings
TOP