50M WIRELESS ROUTER High Speed Wireless Conectivity MT4209 Quick Guide
EN Overview DC input WAN port LAN port Reset switch Configuration steps 1. Into WAN port plug via Ethernet cable Internet connection (other router or ADSL/DSL modem). Into LAN port plug PC computer to configure router. 2. Make sure that network card in Your computer is set to work with DHCP server by obtaining IP and DNS addresses automatically. To check it, choose Properties of Local area cable connection and then, choose Properties of Internet Protocol V4 (TCP/IPv4).
. Launch web browser and enter default address http://192.168.1.1, when password message box appears enter default name “admin” and password “admin”. WAN interface setup Method 1: Automatic obtain (Internet provider DHCP) If you’re using the DHCP (auto config) connection, the router will receive IP parameters from your ISP. Entering any special parameters is not neccesary. Method 2: Fixed IP (for semi-advanced users) 4. Router Management screen will appear (device is set initially to Router mode).
■ Enter Wi-Fi key and click “OK” EN Note: Default SSID and Network key is printed on the serial label on the bottom of the device. ■ To finish connection settings click “Save/Apply” button. Wireless connection to the router For example Windows 7 OS: ■ Navigate to “Start>Control Panel>Network and Internet>Network and Sharing Center>Change Adapter Settings>Wireless Network Connection”. Then right-click “Wireless network connection” and select “Connect/disconnect”.
