User`s guide

DMR160 User’s Guide V2.0 36
Recording Options
The Recording Mode pull-down menu has two options: Standard and Tandberg. In Standard mode,
all commands for starting and stopping the DMR160 are “manual” referring to starting and stopping the
unit via the Web portal or via the REC button on the front of the unit or by any of the other methods
described in this user guide that require user intervention to occur. In the Tandberg mode, the DMR160
will automatically start recording (and streaming if desired) when a call comes into the videoconferencing
system or is initiated by the system and automatically stop once the call has been terminated.
If you select the Tandberg mode, an additional pull-down menu appears for the IP Address of the
Tandberg codec or the serial port used to control the codec. The password of the Tandberg codec is also
required. Enter the IP Address and IP Password of the Tandberg codec’s telnet session and the DMR160
will automatically start when a videoconference call is detected or initiated and will automatically stop
when the call is terminated.