User`s guide

DMR160 User’s Guide V2.0 24
External Control
RS-232
On the back of the DMR160 there is a single control port configured as a DTE supporting the RS-232
protocol. A Null-Modem cable should be used between the DMR160 and the COM port on your PC – the
pin-out is shown here.
Terminal session settings required for RS-232 control are: 9600, 8, None, 1 with No Flow Control.
There is no password protection on this interface and, by default, the RS-232 port is enabled
however the administrator has the ability to disable the port from the Web portal.
See below for a list of the available commands.
For more information on external control, please refer to the MediaPOINTE Command Line Interface
document.