User`s guide

DMR160 User’s Guide V2.0 14
Connecting the DMR160
Use this procedure when you first purchase the DMR160 and when you are ready to install the hardware
at your site. This section shows the back panel and explains how to connect the separate input
connections to the unit. For clarity purposes, INPUTS are shown in RED, OUTPUTS are shown in GREEN
and CONTROL ports are shown in BLUE.
The Rear Panel
AC Power Input – insert the included IEC cable to the AC power input plug. Make sure the Power on/off
switch is in the off position before plugging in the power cable.
Video Inputs – Video inputs 1 and 2 on the DMR160 can be set from the Web portal to be either
composite or S-video inputs.
Stereo Audio Input – there are two, line level stereo audio inputs that use standard RCA connectors.
LAN Cable Input – insert the included standard 10/100Mb CAT-5e LAN cable into the connector labeled
LAN1 on the DMR160. The connector labeled LAN2 is reserved for future use.
The above listed cables are all that are necessary to archive and stream video. The remaining cables and
connectors not mentioned above are for alternate methods of control or for viewing the output of the
DMR160 locally; i.e. connecting a local monitor.