User Manual

Make sure the auger screw is pushed all the way in to the strainer in order for the
feeding tube to close properly.
If the auger screw is not properly in position, the feeding tube may not close.
Different ingredients hold different amounts of fluid that will yield different amounts of
juice.
If the ingredients are not fresh, they may contain reduced amounts of fluid, which will
yield less juice.
Check if the pomace silicon sealer is firmly Inserted.
If the ingredient itself has low water content, it may help to soak it in water before
juicing.
If juicing ingredients with small seeds, after a few servings, it may reduce the juice
yield. For best result, disassemble and wash the top-set in between juicing.
If there is seed residue on the bottom of the strainer, this can affect juicer performance
and the overall juice yield.
The juicing screw and the strainer are set up to crush and squeeze the ingredients. It is
normal for the juicing screw and the strainer to vibrate.
If the ingredient contains strong fiber, the vibration from the top-set may be stronger
Check the power cord and make sure it is plugged in correctly.
Check that all the parts are correctly assembled.
If too many ingredients are inserted at one time, this can cause the juicer to stop.
When the juicer stops because there are too many ingredients inserted in it, press the
“R” - “0” - “ON” button in this order, switching back and forth 2 to 3 times.
The reverse setting will push the ingredients up, and the on setting will pull the
ingredients down.
If the juicer stops due to the overload protection, let the juicer cool for 30 minutes to 2
hours before juicing again.
If there are hard seeds within the ingredients, remove them before juicing. Hard seeds
can damage the juicer.
If the pomace silicon sealer on the bottom of the juicing bowl is not plugged in
correctly, the juice may seep out on to the motor device. Before assembling the parts,
check and make sure the pomace silicon sealer is plugged in correctly.
The feeding tube will not close:
Low juice yield:
During operation, the juicing bowl shakes:
During juicing, the juicer stopped:
Juice dripping down the body of the base:
WE ARE ALWAYS AVAILABLE FOR QUESTIONS
[e-mail]