User Manual

Troubleshooting
Check if the power cord is properly plugged in.
Check if the feeding tube and the juicing bowl are properly assembled.
Check if the top-set and the motor device are properly assembled.
The juicer will not operate if parts are not assembled properly.
Check if the parts are assembled correctly. Try to assemble the parts again and listen
for the odd noise.
Do not start the juicer unless there are Ingredients and/or liquid in it.
Operating the juicer without ingredients can cause damage to the screw.
If the juicer is operated without ingredients or liquid, the noise level can increase and
also can lead to damage.
The friction noise from the auger screw and the strainer in the juicer.
If the noise occurs when ingredients are inserted into the juicer, check the size of the
ingredients. Do not insert anything over 1 inch (2,54 cm) in thickness.
Depending on the type of ingredients, the dimensions can be smaller.
The noise can occur if the juicer is operated on an uneven or slanted surface. Place the
juicer on a horizontally flat surface when operating.
When continuously juicing, and depending on the ingredient, the juice may contain a lot
of fine pulp.
To reduce the fine pulp, clean the top-set frequently and extract the pulp.
Use a mesh strainer and put the juice through it to collect the unwanted pulp.
If the strainer and the auger screw are damaged and affecting the juicer’s
performance, it is recommended the parts be replaced.
The lifetime of each part may vary depending on length and method of use and
ingredients extracted.
If too many ingredients are inserted at the same time, it may cause the juicer to stop
frequently. This can lead to pulpy juice, Insert the ingredients slowly and few at a time.
After juicing, let the juicer operate for another 30 seconds to extract the remaining
pulp.
If there is too much pulp in the top-set, this can cause the drum lid to not open. In this
situation, press the “R” - “0” - “ON” button in this order, switching back and forth 2 to 3
times.
Pour water down the feeding tube to rinse out the inside and then try opening the
feeding tube.
When the juicer doesn't turn on:
Odd noise from the juicer:
There is too much pulp in the juice:
The drum lid is stuck: