User Manual

Note │ When moving the appliance, do not lift by grabbing the feeding tube, please always
lift the appliance by grabbing the motor device or handle.
3. Remove the juicing bowl from the motor device.
4. Remove the auger screw, strainer from the juicing bowl. Clean with provided cleaning
brush.
TIP │ Soak the filter and juicing bowl in a solution of
warm water with baking soda or little bit of bleach
for about half to one hour to clean the excess build
up.
If remaining residue in the juicer dries up, it will be difficult to disassemble and clean.
The excess pulp build up can cause bad performance in future uses.
For easier disassembly, place the top-set in the sink and then run the water through from
the top of the top-set.
Thoroughly dry the bottom of the auger screw where it connects to the metal cylinder
shaft on the motor device.
Note | Immediately clean the juicer after each use.
5. Place the juicing bowl under running water and unplug the pomace silicone stopper to
clean the pulp spout.