User Manual

How to assemble
1. Take the products and accessories out of the packing box, and clean the juicing bowl,
juice cup, strainer, auger screw, feeding tube and pusher.
2. Press the pomace silicone stopper into the juicing bowl (as shown in Fig. 1).
3. Align the juicing bowl “ ● ” with the “ ● ” on the motor device and install it on the motor
device (as shown in Fig. 2), align the three holes at the bottom of the juicing bowl with the
three positioning pillars on the motor device.
4. Align the strainer “ ● ” with the juicing bowl “ ● ” , put it into the juicing bowl, and adjust it
to be flat (as shown in Fig. 3 )
Fig. 1 Fig. 2 Fig. 3
5. Put the auger screw into the center hole of the strainer and rotate it in place (as shown
in Fig. 4). If it is not installed in the required place, the feeding tube will not be able to be
covered properly.
6. Install the feeding tube “ ” with the juicing bowl “ ● ” (as shown in Fig. 5), and rotate it
to “ ● ” with the juicing bowl “ ” (as shown in Fig. 6).
CAUTION: If the feeding tube is not installed in the required place, the product cannot work
normally.