Specifications

176 Hardware Description and Reference for Avaya Communication Manager

Single G650

A single G650, equipped with feet, can be table or floor mounted. Side-by-side G650s,

connected by TDM/LAN cables, are not supported. In a single configuration, the G650 always

has an A carrier address.

Multiple G650s

Multiple G650s, up to five, can be mounted in a rack and connected by TDM/LAN cables to

create a G650 stack. Multiple G650s must be vertically adjacent and their front panels must

align in the same vertical plane. For example, carrier A is always below carrier B, which is

always below carrier C, and so on through carrier E. Note that existing TDM/LAN cables used

for the G600 cabinets are not compatible with the G650.

Multiple G650s, up to five, can be mounted in a rack but not connected by TDM/LAN cables. In

this case each G650 is defined as a port network. Each gateway requires its own interface

hardware (EI, ATM-EI, TN2312BP IPSI). Note that with this configuration, all the G650s have a

carrier address of A.

Carrier addressing

The carrier position, A through E, must be set on all G650s. The carrier address is set using a

small printed circuit card that is plugged into one of five, A through E, connectors inside the

carrier.

See Figure 42:

Printed circuit card on page 176 for an example and location of the printed

circuit card.

Figure 42: Printed circuit card

swdlpdle LAO 072403

-48 VDC

RETURN

TOP