Specifications

142 Hardware Description and Reference for Avaya Communication Manager
J-series Services Router power cord specifications
AC Power Cord
Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied with the
Services Router. The appliance coupler at the female end of the cord inserts into the appliance
inlet on the faceplate of the AC power supply. The coupler is type C19 as described by
International Electrotechnical Commission (IEC) standard 60320. The plug at the male end of
the power cord fits into the power source receptacle that is standard for your geographical
location.
Note:
Note: In North America, AC power cords must not exceed 4.5 m (approximately 14.75
ft) in. length, to comply with National Electrical Code (NEC) Sections 400-8
(NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section
4-010(3). The cords supplied with the router are in compliance.
DC Power Cord
Each DC power supply has a single DC input (-48 VDC and return) that requires a dedicated 15
A (-48 VDC) circuit breaker. If the J6350 router contains redundant DC power supplies, one
power supply must be powered by a dedicated power feed derived from feed A, and the other
power supply must be powered by a dedicated power feed derived from feed B. This
configuration provides the commonly deployed A/B feed redundancy for the system.
Country Electrical
Specifications
Plug Standards
Australia 250 VAC, 10 A, 50 Hz AS/NZ 3112 1- 993
China 250 VAC, 10 A, 50 Hz GB2099.1 1996 and
GB1002 1996
(CH1-10P)
Europe (except
Italy and United
Kingdom)
250 VAC, 10 A, 50 Hz CEE (7) VII
Italy 250 VAC, 10 A, 50 Hz CEI 23 - 16/VII
Japan 125 VAC, 12 A, 50 Hz
or 60 Hz
JIS 8303
North America 125 VAC, 10 A, 60 Hz NEMA 5-15
United Kingdom 250 VAC, 10 A, 50 Hz BS 1363A