User manual

User guide P9-0135-B 14 of 52 Version 1.0.3/2012
Medema Production A/S
Driving the Mini Crosser M-MaxX
Getting in and out
It is important to learn a safe technique for getting in and out of
the Mini Crosser.
In general the following method should be followed:
• Make sure that the Mini Crosser M-MaxX is off (switch turned to
0) when getting in and out, otherwise the Mini Crosser could start
if the accelerator was touched inadvertently.
• Make sure that the brake is on. (Lever for disengaging motor in
top position.)
• Put the steering column in vertical position.
• If necessary, turn the seat through 45° or 90° and make sure that
it is locked in position (clicked into place).
• If necessary, raise the armrest.
For some users the assistance of an attendant can be
recommended. The attendant should:
• Take care not to injure him/herself when lifting/lowering/supporting
the user.
• Make sure that the Mini Crosser is stable and unable to move.
Turn off the Mini Crosser and check that the brake is on and the
seat has been rotated until it clicks into place at either 45° or 90°.
• Make sure that the seat the user is being moved to is stable.
Turn the Mini Crosser off, return the
steering column to upright position, rotate
the seat and raise the armrest.
IMPORTANT!
The Mini Crosser will turn
itself off automatically after
it has been stationary for
10 minutes even if the key
has been turned to driving
position.
To restart the vehicle, the
key must be turned to stop
position (0) and then to driving
position (1).