DRUM AMPLIFIER Owner’s Manual PROFESSIONAL DRUM AMPLIFIER
INFORMATION FOR YOUR SAFETY! THE FCC REGULATION WARNING (for USA) PRECAUTIONS This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Contents Panel Description Front Panel......................................................................................................... 4 Rear Panel.......................................................................................................... 4 Operation Connections ...................................................................................................... 5 Turning on the Power.........................................................................................
Panel Description Front Panel 1. AUX IN jack: for connecting external audio source, such as an audio player. 2. BASS knob: for adjusting the bass (low frequency) level. Rear Panel Fuse Note: 4. INPUT1/2 jacks: for connecting the drum module. 5. POWER switch: for turning the power on or off. 1. Connect the speaker to the specified power supply. Not using the specified power supply may destroy the fuse. For connecting the power cord AC IN F1AL250V 3.
Operation Connections 1. Connect the power cord to the AC IN jack on the rear panel. Then plug the power cord to the power outlet. 2. Use an audio cable to connect the drum module to the INPUT 1 or INPUT 2 jack of the speaker. Turn on the power of the speaker, then rotate the volume knob to adjust the volume level. INPUT 1 and INPUT 2 can be used interchangeably, for the convenience of connecting two sound sources.
Operation Turning on the Power 1. Make sure all volume knobs on the speaker and the connected devices are set to “0”. 2. Turn on the devices connected to INPUT 1 and INPUT 2. 3. Turn on the power of the speaker. Note: Before turning on the power, always turn down the volume level. Even when volume level is set to minimum, when turning on the power, you may hear a sound. This is normal. It doesn’t indicate any malfunction. 4. Adjust the volume levels of all devices.
Specifications Power supply AC 220-240V 50/60Hz Rated power output 35 W Input impedance Input1: 100kΩ Input2: 100kΩ Input sensitivity Input1: -38dB Input2: -38dB EQ Bass: +/-10dB@60Hz Treble: +/-10dB@10KHz Aux In 3.
AP33_OM07EN
