User Manual

be
* Adjust the volume to a comfortable level.
convenient
Make sure the power is switched OFF and connect the power
adaptor with the DC IN jack on the side panel.
Note:
1. To protect the speakers, amplifier and the drum module from
damage, rotate the volume knob to the minimum volume level
before switching the power ON.
2. Make sure the power is switched OFF when connecting drum
module with external devices.
Connecting an Audio Equipment
Connecting a set of headphones
Power supply& Switch
Amplifier Amplifier
MIDI stands for Musical Instrument Digital Interface, this is a
world-wide standard communication interface that enables
electronic musical instruments and computers (of all brands)
to communicate with each other so that MIDI command and
other data can pass between them. This exchange of information
makes it possible to create a system of MIDI instruments and
devices that offer far greater versatility and control than is
available with isolated instruments. Whether you interface with
computers, sequencers, expanders or other controllers, your
musical horizons will be greatly enhanced.
MIDI connection
MIDI OUT: This terminal transmits data from this instrument
to other MIDI devices.
USB connection
The USB connector allows you to connect the module directly to
your computer. It can be connected without driver installation
under the Windows XP\ Vista\Windows 7& MAC OSX environment.
The modulewill be recognized as 'USB Audio device' to receive and
transmit MIDI messages through a single USB cable, USB is used
MIDI and USB
only for MIDI messages(MIDI via USB).
Note: When the USB is connected to a computer, all MIDI messages
will be received and transmitted via USB.
6
the PHONES jack located on the side panel of the drum module.
An optional set of stereo headphones can be connected with
When using an amplifier, connect the Output L/MONO
and R jacks on the rear panel to the input of the amplifier.
Note:
For mono playback, use the L/MONO jack.
For stereo playback, connect both L/MONO and R jacks.
The line output volume is controlled by the VOLUME knob.
Connecting an MP3/CD Player
Connect the audio output of an MP3/CD player or other audio
source to the stereo AUX IN jack on the rear panel.
The input signal is mixed with the drum signal,
allowing you to play along.