User's Manual

Medeco Hybrid User Guide
9 of 16
value, the Hybrid MCU will be shut down to a minimum power state with no key-
detection.
5.3 Tamper Alarm
The Hybrid MCU contains tamper circuitry that detects if the outer cover is
removed or power is lost for any reason. If the tamper condition is detected a
transaction will be stored. A tamper condition will cause the Hybrid MCU to reject
all user keys until reset by presentation of the Master key.
6 Installation Procedures – Mortise Application
For the purposes of these instructions the Hybrid reader assembly (inner
housing) is referred to as the MCU and the Hybrid lock cylinder assembly is
referred to as the LCU.
6.1 What is required:
Hybrid installation kit
Lock cylinder assembly with proper cam (LCU)
Reader unit (MCU)
Outer cover
Housing spacers
Base plate
Lock Ring
Mounting screws
Battery
User key with correct mechanical keyway and cut
Hybrid 125KHz Prox key head
PDA programming device
Programmed from the Hybrid Manager software
Including access rights for the User Key
The functionality to set the MCU clock
Hybrid Manager Software (Not covered in this document)
6.2 Installation procedure when MCU is programmed at the door
6.2.1 Remove mechanical cylinder from lockset. (if applicable)
6.2.2 Verify proper cam on Hybrid cylinder for target lockset.