User's Manual

Medeco Hybrid User Guide
13 of 16
The MCU flashes the LED green, red, green to indicate the master key was
accepted but no LCU was found.
MCU resets the tamper condition
MCU turns on the IR communications port - The MCU will flash the LED red
when the IR communications session times out.
6.3.4 Program the Hybrid unit with the PDA – PDA should be loaded with key
list (including User key used for installation)
6.3.5 Present the PDA to the MCU – IR port on PDA must be active
6.3.6 Present the master key to the MCU
MCU reads the master key and flashes LED green, red, green to indicate (Master
key valid, No LCU connected, IR port turned on)
The PDA communicates with the MCU via the IR link and uploads a key list and
schedules etc. into the MCU
The PDA sets the clock in the MCU
The MCU will flash LED green at the completion of the communications session.
(The MCU will flash the LED red if the IR communications session times out prior
to completing the communications session.)
Note: The MCU battery should be removed until the unit is installed at the door.
6.4 Installation procedure when MCU is programmed in advance.
6.4.1 Remove mechanical cylinder from lockset. (if applicable)
6.4.2 Verify proper cam on Hybrid cylinder for lockset.