Installation Guide

ManualsBrandsMedeco Security Locks ManualsElectronicsEA-100102 Hybrid Rim & EA-100103 Hybrid Mortise

12/04/07

Revision 1.0

1 of 6

Medeco HYBRID eCylinder

Installation Procedures – Mortise Application

1. What is required:

Hybrid cylinder kit

Hybrid Cylinder (LCU) with proper cam

MCU reader unit

MCU outer cover

MCU spacers

Base plate

Lock Ring

MCU mounting screws

Battery

User key with correct mechanical keyway and cut

Hybrid 125KHz Prox key head

PDA programming device

Programmed from the Hybrid Manager software

Including access rights for the User Key

The functionality to set the MCU clock

Hybrid Manager Software

2. Installation procedure when MCU is programmed at the door

2.1 Remove mechanical cylinder from lockset. (if applicable)

2.2 Verify proper cam on Hybrid cylinder for lockset.

2.3 Rotate cam on back of Hybrid cylinder to home (locked) position – This

removes the cylinder from the shipping (unlocked) position and mechanically

“arms” the Hybrid cylinder. A properly bitted key must now be used to operate

the lock cylinder.

2.4 Install (screw) the Hybrid cylinder into the lockset. Check for operation with

the lockset using the User key to operate the cylinder mechanically. Adjust the

cylinder as necessary for door thickness, cam engagement, etc.

2.5 When cylinder adjustments are complete, tighten set screw in lockset to

secure cylinder in place.

Summary of content (6 pages)

PAGE 1
2/04/07 Revision 1.0 Medeco HYBRID eCylinder Installation Procedures – Mortise Application 1.
PAGE 2
12/04/07 Revision 1.0 2.6 Install base plate and lock ring to secure lock cylinder to door. Install spacers as required for thin door applications. 2.7 Place cylinder in locked position and remove the User key. User key is no longer needed until Hybrid unit is programmed. 2.8 Ensure the battery is removed from the MCU unit. 2.9 Connect the cable from the cylinder to the back of the MCU unit. 2.10 Locate and install the MCU onto the base plate using the four mounting screws.
PAGE 3
12/04/07 Revision 1.0 MCU registers with the LCU MCU establishes authorization with the LCU MCU turns on the IR communications port. The MCU will flash the LED red when the IR communications session times out. 2.14 Program the MCU with the PDA – PDA should be loaded with key list (including User key used for installation) 2.15 Present the PDA to the MCU – IR port on PDA must be active 2.
PAGE 4
12/04/07 Revision 1.0 3.2 Install the MCU outer cover The tamper switch will be reset The MCU will start to search (ping) for a credential At this point: MCU is still in tamper mode MCU has no master credential identified and stored MCU and LCU are not registered to each other – No LCU connected MCU and LCU are not authorized with each other – No LCU connected MCU clock is not set MCU is not programmed with a key list, schedules, etc. 3.
PAGE 5
12/04/07 Revision 1.0 The MCU will flash LED green at the completion of the communications session. (The MCU will flash the LED red if the IR communications session times out prior to completing the communications session.) Note: The MCU battery should be removed until the unit is installed at the door. 4. Installation procedure when MCU is programmed in advance. 4.1 Remove mechanical cylinder from lockset. (if applicable) 4.2 Verify proper cam on Hybrid cylinder for lockset. 4.
PAGE 6
12/04/07 Revision 1.0 The LCU will power up and “arm” the electronic blocking mechanism (mechanical key alone will no longer operate lock) 4.