User Manual

MedeaWiz® Sprite®
.
25 | P a g e
Serial Port Control Multi-Drop Addressing Wiring
Multiple Sprites may be connected to a single serial control bus.
You can use one serial output from your controller to control multiple Sprites.
Connect all of the Grounds together and connect all of the RX Inputs together, and to your
controller’s TX output.
Set an address on each Sprite® and it will only respond to commands from your controller
preceded by that same address. More than one Sprite can have the same address if you want
them to respond the same commands.
Limitations on the number of Sprites on the bus include length of wire, type of wire and baud
rate. Low capacitance wire and lower baud rates will allow longer distances and / or more
Sprites on the bus.