Manualshelf

User Manual

ManualsBrandsMedeaWiz ManualsElectronicsMedeaWiz DV-S1 Sprite Looping HD Media Player – Seamless Audio Video Auto Repeater 1080p 60Hz HDMI, NTSC, PAL Output Trigger and Serial Control
11121314151617181920
MedeaWiz® Sprite®
.
12 | P a g e
Address Mode
Select an address, if desired, for serial communications.
Only applies if the setting Control Mode is set to Serial Control.
Do not use addressing
If you are using a single Sprite® on the serial communications line, or using a Hydra® input
expander, in most cases you should choose the Do not use addressing option.
Address set to 0xE1, 0xE2, 0xE3, 0xE4, 0xE5
If the Sprite® is set to an Address, then the Sprite® will only follow commands preceded by the
correct address.
The Host can transmit commands to many Sprites on the same serial line.
This requires a 2 byte transmission, Address, Command. i.e. 0xE1,0x03 will play the file named
003 on any player with an address that is set to 0xE1.
You can only use 1 Sprite® for the feedback to the Host to avoid data collisions.
You should only connect the RX inputs and Grounds of multiple Sprites together.