User manual

Page6
TV OUTPUT SETTINGS
Connect the Mede8er to your TV by one of the connection options as shown on page 4 and change the
input option on your TV to match the option you selected. If you do not get to see the Mede8er GUI on your
TV you will need to toggle the Mede8er TV output until you get a picture.
TV SYS Toggle Procedure
The MED400X has two video output options ie Composite Video (yellow)
RCA connectors and HDMI. Each output option also offers different
screen resolution settings and these will need to be adjusted to
match the type of TV used.
To change the Video Output on the
Mede8er just press the TV SYS button
or the TV SYSTEM button on the
remote and it will change the Video
Output to the next available output
option. If after pressing the TV SYS
button you still do not get a picture
then after a short pause press the
TV SYS again until you see the
Mede8er GUI on your TV. Keep
repeating this procedure until you
see a picture on your TV.
AUDIO SETTINGS
HDMI Downmix (2 channel)
Use this setting if you are connecting the Mede8er directly to the HDMI input on your TV. The
sound will be downmixed to 2 channel stereo.
HDMI Passthrough
Use this setting if you are connecting to the HDMI input of a Home Theatre Amplifier. The audio will be
passed through as Bitstream or LPCM and the amplifier will do the multichannel decoding.
SPDIF Downmix (2 channel)
Use this setting to connect to a Amplifier via Toslink optical cable or Co-Axial Digital RCA cable.
The sound will be downmixed to 2 channel stereo.
SPDIF Passthrough
Use this setting to connect to amplifier via Toslink optical cable. The sound will be passed
through as Bitstream or LPCM and the amplifier will do the multichannel decoding.
Once you see the Mede8er GUI on your TV then you must enter the Video Setup
mode and adjust the Video settings to match the screen size resolution of your
TV.