User manual

POWER UP AND STANDBY
Plug the AC/DC adapter into the mains outlet and plug the DC Jack into the DC IN at the rear of the
MED300X. DO NOT USE ANY AC/DC ADAPTER AND ONLY USE THE ONE SUPPLIED otherwise you
may cause damage to the unit. Press the On/ Off button on the Mede8ers front panel and front facia LED
will turn on Blue. You can put your Mede8er into standby by pressing the On/ Off button on the remote.
When in standby the front facia LED will turn Red.
Page6
USB CONNECTION TO PC
You can transfer files to and from the Mede8er via fast USB2.0 transfer. Use the included USB cable to
connect the Mede8er MED300X to your PC. As soon as the USB cable from the Mede8er is connected to
your PC the Mede8er will connect. The computer will automatically install the correct drivers and you will be
able to navigate the Mede8er like any normal external USB drive. Note: Some Computers may take up to a
few minutes to install the correct USB drivers.
EXTERNAL USB DEVICE DRIVER NOT REQUIRED