User manual

Page4
INSTALLING A HARD DRIVE
a) b)
c)
Make sure that the DC cable is unplugged.
cover screws x and y. Lift the hard drive cover and remove it, place it on a flat surface with the mounting
tabs facing upright. Fit a compatible SATA hard drive into place with the label facing upwards and the
connectors facing the side with the air vents. Secure the hard drive with the four screws provided.
Connect the hard drive power connector and the red SATA data connector from the player to the hard drive
diagram c. Re fit the hard drive cover into the Mede8er body and tighten the two securing screws x and y.
To reduce hard drive vibration noise you can use the supplied Neoprene pads. Just peel of the adhesive
side and stick onto the base as indicated in diagram d.
Turn the Mede8er upside down and unscrew the hard drive
SATA
d)
Lift cover from
this side
x
y
FORMATTING THE HARD DRIVE
To Format a new Hard Drive go to Setup Menu and select Hard Drive Format and follow onscreen
instructions.
WARNING: FORMATTING THE HARD DRIVE WILL ERASE ALL DATA