Owner Manual

WINDOW ASSEMBLY (9309 - 9329)

Open Hood and lay Window Glass (28) into window recess. (FIG O)

Insert Carriage Bolt (29) from outside of Hood through hole and install Window Retainer Clip (30) on Bolt. The

Long Flange of the Retainer Clip should be against the Window. Put Wing Nut (31) on Bolt, Tighten with ﬁ ngers

until snug.

NOTE: DO NOT OVER TIGHTEN

Repeat for the other side. Window assembly should look like (FIG P) when complete.

CAUTION: This is a heat resistant tempered glass. Take care not to drop water on hot glass.

FINAL ASSEMBLY (ALL GRILLS)

Lift Rotisserie Lock and move Control Housing to horizontal element position. Set the Cooking Grid (8) on the

two Rear Bumps in the back of the Grill Bowl and the two support studs in the front of the Bowl. (FIG Q)

Your grill is now ready for use, but FIRST READ SAFETY PRECAUTIONS AND ALL OPERATING INSTRUCTIONS IN

THIS OWNER’S MANUAL BEFORE USING YOUR GRILL.

(FIG P)

Long

Flange

Carriage Bolt

(FIG O)

(FIG Q)