User Guide

MECHA User’s Guide v.05.4 ! Dual Axis

Pairing PIN for more than 2 MECHAs

This sec!on should be read a'er you read DAC test using the UI, where we

explain how to access the user interface.

The Pairing PIN is an extra op!on you can use when the pairing method is

zLM or zLM 2, to pair automa!cally at start more than 2 MECHAs

connected to the same network or to the same hot-spot.

To set a pairing PIN number:

• Access the MECHA-H web interface, as shown in the chapter DAC test

using the UI, and go to /con#g page.

• Create a four-digit number - the pairing PIN - and enter this number in

the %eld Pairing PIN.

• Then click on [Apply] bu"on at the bo"om of the page.

All MECHA units which have the same PIN, will be paired together.

All pairing methods and requirements presented in this guide are s!ll

valid.

Once paired, if the PIN is changed in MECHA-H, it will be automa!cally set

the same in MECHA-V.

If you want to break the pairing, please set a di>erent PIN in MECHA-V.

Temporary pairing

This type of pairing, or team, only lasts un!l the MECHA units are powered

o>. To temporary pair two MECHA units:

• Power up both MECHAs.

• Start team building entering the code 1212< on horizontal MECHA. In

other words, the unit on which you enter this code, will rotate

horizontally.

• Con%rm the par!cipa!on in the team, entering the code 12< on ver!cal

MECHA. This unit will rotate ver!cally.