User Guide

MECHA User’s Guide v.05.4 ! Dual Axis

In the loop, we have only the !l!ng of 3° for MECHA-V, and no changes for

H interval.

The above loop repeats with -3° instead of 3° for MECHA-V:

=10(^-3_30, =^-3),

EXAMPLE 8

Script for 28mm on a full frame camera: two images =0° apart for both

zenith and nadir. 2 rows of 10 shots at 5;° above _ below horizontal, and 12

shots around for the horizontal. 36 shots in total. Start in parked posi!on

*zenith+, and end in raised posi!on *nadir+.

S=90, 1=0_0, =_30, 11=-45, =_36, 9=45, 10=90,

=_90, =-90_0, =_-90, =

S=90, - start posi!on is parked.

1=0_0, - %rst shot is at 0,0 *no rota!on+.

=_30, - the next shot is at the same !lt, but 36° apart, and will keep going so

11=-45, - then at the 11th shot from the previous change, the !lt becomes

-45 and

=_36, - the next shot is at the same !lt, but 36° apart, and will keep going so

9=45, - then at the 9th shot from the previous change, the !lt becomes 45,

and

10=90, - then at the 10th shot from the previous change, the !lt becomes

90 for zenith, and

=_90, - the next shot is at the same !lt, but 90° apart *the second zenith

shot+

=-90_0, - then at the next shot, the !lt becomes 90 for nadir, and

=_-90, - the next shot is at the same !lt, but 90° apart *the second nadir

shot+

= end.

To end in parked posi!on, as it started, in order to repeat it again and again:

S=90, 1=0_0, =_30, 11=-45, =_36, 9=45, 10=90,

=_90, =-90_0, =_-90, =90