User Guide

About bu"ons
The bu"ons [1], [2], and [3] are used to enter some numeric selec!ons, or
to enter speci%c codes.
About UI vs. Codes, or Bu"ons
MECHA can be controlled mainly in two ways: using the web User Interface
*abbreviated UI+, and using its own bu"ons.
Always start by powering up MECHA, by pressing and holding power bu"on,
⏻, for 3 seconds. A beep will be heard and the LEDs will light up.
Although MECHA can be controlled via its own bu"ons, some!mes, for
more complex tasks, or to assign complex tasks to a single bu"on, the UI can
be used.
But, before diving in assigning complex tasks to bu"ons, it’s worth to
men!on that MECHA has an unique set of features 4 zLM which stands for
zero Learning MECHA 4 which are speci%c designed to allow the use of
MECHA without learning something new.
The power bu"on, ⏻, is used to power ON/OFF MECHA, to con-
%rm or cancel some opera!ons, and it is also the equivalent of
the number 0 *zero+ when power codes are entered.
Bu"on [1] 4 comes pre-programmed with 5 shots around. Use it
to enter the number 1.
Bu"on [2] 4 comes pre-programmed with 6 shots around. Use it
to enter the number 2.
Bu"on [3] 4 comes pre-programmed with 8 shots around. Use it
to enter the number 3.
Le' v and right w bu"ons are used to rotate MECHA manually
to the le', or to the right, and also to specify direc!ons when
launching the presets using bu"ons, as terminator for codes.
!
1
3
2
© 2020 FANOTEC
MECHA User’s Guide v.05.4
9