User Guide

MECHA User’s Guide v.05.4 ! Dual Axis

• 8:45 4 8 posi!ons from now on *2nd MECHA will !lt to 5;°+

• 6:60 4 6 posi!ons from now on *2nd MECHA will !lt to 60°+

Now, something di>erent: instead of saying 2:90,

which means two posi!ons at a !lt of =0° *which will turn to be 180° apart,

and it could be good as well+, we say 2^90:90,

which means two posi!ons =0° apart at a !lt of =0° 4 for example, for two

Nadirs =0° apart 4 then the same for two ~eniths 2^90:-90,

then go back to 0° !lt.

Changes can be made to this presets as well.

If you need more rows, for exemple two extra rows, change the numbers of

repeats by click on Repeat and enter, via Custom, 10^1 instead of 8^1.

Suppose we need 2 more rows at

-70 made of 4 posi!ons each:

P10:-12,8:-45,6:-60,4:-70,10:12,8:45,6:60,4:70,

2^90:90,2^90:-90,0

If we want the order of rows to be changed, their posi!on in the list of

angles can be adjusted, for exemple, with the posi!ve !lts %rst:

P10:12,8:45,6:60,4:70,10:-12,8:-45,6:-60,4:-70,

2^90:-90,2^90:90,0

Again, the Repeat must be set at Repeat 10+1 sec.

If, for some reasons, more seconds are needed between rows 4 for

example, ; seconds 4 the Repeat can be set at Repeat 10+5.

Also, the number of posi!ons can be changed as well:

P12:12,10:45,8:60,6:70,12:-12,10:-45,8:-60,6:-70,

2^90:-90,2^90:90,0

Then you can click on [Save 1] to save and assign this preset to bu"on [1] of

MECHA-H-DAC. From now on, you can launch this preset by simply press [1]

then w *for clockwise rota!on+ when MECHA is idle, or press [1] then v *for

counter-clockwise rota!on+

Also, you can click on [Save] bu"on to save it on MECHA, in the Presets list,

with a desired name.